Hello,

I've built a large Delta 3D Printer, I finally finished up the build and set up the configuration file so that now I can start printing. Unfortunately it looks like the printer is freezing during prints. When it begins to print it will first wait for the bed and extruder to reach the desired temp and then start to print. It prints well for a few layers and then will randomly freeze. The extruder and bed hold their temps fine but the head just stops moving and the panel says it's paused. When I try to un-pause it with the pause button on the smoothieboard, nothing happens.

So far the only things that I tried to print have been the Hollow Cube, Hollow Pyramid and 40mm Cube. I'm using slic3r to generate the G-Code.

Looking forward to getting advise!
Thanks,

-Helipad14399

Ok,
So I have had a little bit of time to further explore my freezing issue, I've noticed a couple of things:
- Mosfet for Heated Bed is very hot
- Smoothieboard freezes after I've "played" a G-Code
- When Smoothieboard freezes, it does so randomly

My question now is whether my slic3r settings are causing Smoothieboard to crash? Also, why is my Mosfet so hot?

Looking forward to hearing from somebody!
Thanks,

-Helipad14399