There are two solutions:
LED Tactile Button:
solder Led Tactile Button on the smoothieboard
Simple Button:
Wire a simple button on two pin
The button may be configured as a kill switch, this will halt all operations and turn off heaters and pause the host. It can be cleared with a M999 or reset. to enable a kill button the following is added to the config…
kill_button_enable true # set to true to enable a kill button
kill_button_pin 2.12 # kill button pin. default is same as pause button 2.12 (Add ^ for external buttons)
When in the halted state (after kill button is pressed) the play led will flash rapidly.
Stopping Smoothie
These are the different ways of stopping Smoothie :
| Command | G-code | Movement | Heaters | File playing | Recoverable | Documentation | Explanation |
|---|---|---|---|---|---|---|---|
| abort | M26 | Stops an SDCARD print immediately | Not affected | Aborts | Position maintained, but file must be restarted | Player | Stops the execution of a file being played from SDCARD, it will complete the current gcode, but stop immediately after that, the rest of the queued commands are discarded. It attempts to maintain the correct position after the abort. |
| suspend | M600 | Stops once queue is empty | Turned off if option enabled (default) | Paused, can be resumed | Yes, with resume or M601, position maintained | Player | Suspends the execution of a file being played from SDCARD or being streamed from a host (upstream support required currently pronterface and octoprint support it, otherwise host needs to be manually paused), all state is saved and jogging and extruding is allowed. Mainly used for mid print filament change, or filament out detection. M601 resumes the print or the resume command |
| No command, but there is a configurable «kill» button | M112 | Stops instantly if kill button pressed, if issued from host has to wait for the receive buffer to have room. | Turned off | aborted | No, position is lost, home will be required | supported-g-codes | Instantly stops all operations, printer fully halts until M999 is sent. Position is lost. |
If the kill button is pressed (or there is a temperature fault, M112 is issued, a limit switch is hit or other error) the system enters the Halt state, in this state the play led flashes, and the state can be cleared by issuing M999 or holding the flashing kill button for 2 seconds (it can also be cleared from the LCD panel). While in the Halt state any command issued from the host will get a !! response (with a few exceptions). The PSU may be turned off when Halt is entered if there is a psu Switch defined.
All commands can be triggered by a button or a sensor if a Switch module is configured to do so.
